DPU 100-70Les 8 Troubleshooting
Operator's manual 49
5. Start the engine.
If the engine does not start after a maximum of 15 seconds, cancel start at-
tempt and contact your Wacker Neuson representative.
6. Let the engine run for a few minutes.
7. Disconnect the clamping pliers of the black booster cable from the grounding
point on the machine.
8. Disconnect the second clamping pliers of the black booster cable from the
donor battery.
9. Disconnect the clamping pliers of the red booster cable from the positive ter-
minal of the discharged battery.
10. Disconnect the second clamping pliers of the red booster cable from positive
terminal of the donor battery.
To Next Page
Loading...
