RD 16 Operation
wc_tx001075gb.fm 35
3.5 Rotating Beacon (if equipped)
See Graphic: wc_gr002957
The rotating beacon (34) powers up when the ignition switch is turned
to the ON position. The beacon illuminates and rotates when powered
up.
To install the beacon:
3.5.1 Slide the rotating beacon onto the light staff.
3.5.2 Tighten the wing nut on the base of the light.
3.6 Backup Alarm (if equipped)
The backup alarm is located on the rear of the machine.
Start the engine and move the forward/reverse control to the reverse
position. The backup alarm should sound immediately. The backup
alarm will continue to sound until the forward/reverse control is moved
to the neutral position or to the forward position.
If the backup alarm does not sound, make the necessary repairs
before using the roller.
To Next Page
Loading...
