RD 16 Operation
wc_tx001075gb.fm 41
3.12 Articulation Joint Lockarm
See Graphic: wc_gr002956
A lockarm (23), located below the articulated joint, is provided to
secure the front and rear halves of the roller together. Once secured,
the lockarm prevents the two halves from swinging together.
To avoid being pinched by machine halves, set the lockarm before
lifting the machine for transport or repairs!
To set lockarm, release it from its holder and swing it out from its stored
position. Place the forward end of the arm into the hole provided in the
front frame of the machine. Secure it in this position using the large
hairpin cotter provided.
ALWAYS disengage and stow locking bar for the articulated steering
joint before operating machine. The machine cannot be steered when
the locking bar is engaged.
WARNING
WARNING
wc
gr002956
23
To Next Page
Loading...
