10
PXM
OPERATING AND ASSEMBLY MANUAL
VERSION 08/2015 ORDER NUMBER DOC2350372
2 CORRECT USE
2.1 DEVICE TYPE
Powder center for feeding uidized powder lacquers
2.2 TYPE OF USE
The PXM powder center is used to feed uidized powder lacquers from a powder tank
(including original tank) to several guns at the same time.
2.3 USE IN POTENTIALLY EXPLOSIVE AREAS
2.4 SAFETY PARAMETERS
The PXM powder center is intended for construction outside of the dust Ex-zone (Zone 22).
WAGNER accepts no liability for any damage arising from incorrect use.
Use the device only to work with the products recommended by WAGNER.
Operate only the device as a whole.
Do not deactivate safety xtures.
Use only WAGNER original spare parts and accessories.
The device may only be operated under the following conditions:
The operating personnel must be trained on the basis of this operating manual.
The safety regulations listed in this operating manual must be observed.
The operating, maintenance and repair information in this operating manual must be
observed.
The statutory requirements and accident prevention regulation standards in the country
of use must be observed.
The powder center may only be used if all parameters are set and all measurements/safety
checks are carried out correctly.
To Next Page
Loading...
Need help?
General
