56
PXM
OPERATING AND ASSEMBLY MANUAL
VERSION 08/2015 ORDER NUMBER DOC2350372
7.7.2 MACHINE PARAMETERS OPERATION
Home page
Cleaning
Settings
Alarm
Work-
station
FP
supply
Exhaust
system
Diagnosis
Fault trigger delay powder
shortage
Settings System
Standard
RP
supply
Parameter: Explanation:
Fault trigger delay powder
shortage
Delay time after which an error message is triggered in
the case of powder shortage
WS cylinder lowering
Feeding rate [sec]
Period of time in which the workstation cylinder is
supplied with compressed air during raising and lowering
WS cylinder lowering
Break time [sec]
Period of time in which the workstation cylinder is not
supplied with compressed air during raising and lowering
Time setting for level
controller [sec]
Delay time after which the linear motion unit lowered
during a powder shortage and the fresh powder pump
is switched on
The settings in the "Operation" machine parameters are normally not changed since they
are defined by the installed hardware.
WS cylinder lowering
Feeding rate [sec]
WS cylinder lowering
Break time [sec]
Time setting for level
controller [sec]
MP
operation
MP
cleaning
To Next Page
Loading...
Need help?
General
