Safety Instructions
18
SAFETY, CONTROL, AND INSTRUCTION DECALS
Safety, Control, and Instruction Decals are installed on the machine;
if any are missing, illegible, or damaged, a replacement should be ordered and installed before
putting the machine into operation. The Decal Part Number is listed below and in the Parts Manual.
1. Warning – read Operator’s Manual before oper-
ating the machine.
● Warning – wear eye and ear protection when
operating the machine.
2. Throttle
● Move lever forward to increase engine
speed; back to idle.
3. Warning – roll-over hazard.
● Do not operate on slopes greater than 15
degrees.
4. Warning – thrown object hazard.
● Keep bystanders away from the machine
when operating.
5. Warning – entanglement hazard.
● Keep all guards in place while engine is run-
ning.
Location: LH Fender
Part Number: 8600-37
3.
4.
2.
1.
5.
Location: Engine
Part Number: 6895-103
Change engine oil and oil lter every 300 hours.
To Next Page
Loading...
Need help?
General
