Safety Instructions
16
SAFETY, CONTROL, AND INSTRUCTION DECALS
Safety, Control, and Instruction Decals are installed on the machine;
if any are missing, illegible, or damaged, a replacement should be ordered and installed before
putting the machine into operation. The Decal Part Number is listed below and in the Parts Manual.
Location: Flex Coupler Guard in Front of Engine
Part Number: 8600-2
1. Warning – entanglement and cutting/dismem
berment hazards.
● Keep away from rotating shafts, belts, and
other components.
Location: Right Fender
Part Number: 2802-4
Location: Underside of Rear Body
Part Number: 2107-5
1. Ground drive belt routing.
2. PTO clutch belt routing.
1. Warning – do not operate the machine without a
deck or other implement attached.
2. Forward Speed Control
● Move lever forward to increase speed; back
to stop.
3. Body Tilt Latch
● Raise lever to release.
● Lift at back of body to raise.
4. Warning – do not engage PTO clutch with PTO
shaft disconnected.
5. PTO Clutch Lever
● Move lever forward to engage PTO clutch;
back to disengage.
1.
8600-2
2.
3.
4.
5
1.
1.
2.
Location: Engine Shroud
Part Number: 5855
To Next Page
Loading...
