EasyManuals Logo

Walker S18 User Manual

Walker S18
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #53 background imageLoading...
Page #53 background image
Maintenance Instructions LUBRICATION
49
LUBRICATION
WARNING
DO NOT attempt to lubricate the machine
with the engine running. Disengage the
PTO clutch, shut o󰀨 the machine, and re-
move the ignition key.
Proper lubrication is an important maintenance pro-
cedure. It reduces wear and makes the machine
quieter and easier to operate.
Engine Oil
Engine Break-In Oil
No special break-in oil is required. The engine is
serviced with 10W-30, Service Class SJ oil from the
factory. Change the oil after the initial engine break-
in period of 8 hours. Thereafter, change oil after
every 100 hours of operation.
Checking Engine Crankcase Oil Level
Check the engine crankcase oil level before use and
after each 8 hours of continuous operation.
IMPORTANT: The importance of checking and
maintaining the proper crankcase oil level cannot be
overemphasized. Check the oil level BEFORE
EACH USE.
1. Park the mower on a level surface with the en-
gine stopped. Also, make sure the engine is
cool and oil has had time to drain into the sump
[allow at least ve (5) minutes after stopping
the engine].
IMPORTANT: NEVER check or add oil with the
engine running.
2. Before removing the dipstick, clean the area
around the dipstick to keep any dirt or debris out
of the engine.
3. Remove the dipstick, wipe o󰀨 with a clean rag,
then reinsert the dipstick into the tube and press
all the way down.
4. Remove the dipstick again and check the oil lev-
el on the dipstick. The oil level should be within
the “Operating Range” on the dipstick (between
the LOW mark and the FULL mark).
IMPORTANT: DO NOT operate engine without
a su󰀩cient oil supply in the crankcase. DO NOT
operate with oil level below the LOW mark or
above the FULL mark on the dipstick.
5. If additional oil is needed, refer to Specications
for proper crankcase lubricant. Fill up to, but
not above, the FULL mark on the dipstick.
IMPORTANT: DO NOT overll the crankcase
(oil above FULL mark) as this CAN result in en-
gine overheating, loss of power, and possible
engine damage.
{
FULL
Mark
Operating
Range
LOW
Mark
Dipstick Operating Range

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Walker S18 and is the answer not in the manual?

Walker S18 Specifications

General IconGeneral
Drive SystemHydrostatic
Cutting Height1.5 - 4.5 inches
EngineKohler
Cutting Width48 inches
TransmissionHydrostatic

Related product manuals