- 70 -
en
Installation
Heater installation
Country specific regulations shall be followed in any installation.
The warranty of boat products is valid only in boat installations.
The warranty is not valid in installations to vehicles or other spaces.
The device is meant for marine pleasure craft use. The device is not designed for
continuous use for example in live aboard boats or commercial settings. In such
use the device will require more frequent servicing not covered by warranty.
Things to note when selecting the installation location
The device shall be installed into a dry space in a protected location.
The device must be mounted to a solid, stable bulkhead or wall.
When installing, please note that the device needs to be removable for servicing.
Connections and location should be made so that the device can be easily discon-
nected for removal. For maintenance, it is useful to leave 200 mm (7
7
/
8
”) empty
space below the heater for the removal of the bottom cover of the heater.
The heater should be installed vertically level when the boat is on an even keel.
The static inclination must not exceed 5°. While the device will tolerate being
temporarily tilted to a steep angle (even for some hours), the burner will not yield
optimal performance if it is constantly inclined.
Please note specially the following things:
• Avoid installing the control panel in the immediate vicinity of a water outlet.
• If possible, install the control panel on a vertical surface.
• Select the place of installation to allow a minimum amount of bending in the
warm air ducting.
We recommend that the device be installed by an authorized Wallas service shop
or installer.
Things to note when installing pipes, hoses and cables
Power cables, warm-air ducting and fuel hoses must be protected in locations
where they are susceptible to mechanical damage due to sharp edges or heat.
All cables and hoses should have a fl uid precluding “drip loop” to prevent water or
other fl uids from following wires or hoses to the heater.
Installation space
The device can be installed within the heated space or outside of it.
The heater cannot be installed into a space which may include
gasoline fumes (danger for explosion).
1800 t / 2400 t
490535
To Next Page
Loading...
Need help?
General
