Walz MINI-PAM - Page 103

CHAPTER 13 APPENDIX
Command Corresponding
point in
MODE-menu
Description
li or lix 20: Light curve start-intensity
lw or lwx 19: Light curve step width
m1/m0 3: Measuring light on/off
ma or max 51: Mark of sample (x = A ... Z)
mb1/0 5: ML-BURST function on/off
mf1/0 4: ML-frequency (20/0.6 kHz)
mi or mix 50: ML-intensity (x = 1 ... 12)
me or mex 38: MEMORY-number (x = 1 ...
4000)
mez 39: CLEAR-MEMORY (attention!
data will be erased)
npq 27: NPQ-parameter
o or ox Display of data set Mem.x
o+ or o+x Display of data sets from 1 to x
of Display of data set format
pao MINI-PAM switched off
pas Display of present MINI-PAM
settings
paz 36: MINI-PAM settings reset to
standard
qn 26: Display of present qN
qp 26: Display of present qp
s Start saturation pulse
si or six 47: Sat. pulse intensity (x = 1 ... 12)
sw or swx 46: Sat. pulse width (x = 0.4 ... 3.0)
t 1: External temperature
ti 35: Internal temperature
tox 42: External temperature offset
tgx 43: External temperature gain
tim(hhmm) 31: Time (hour minute)
ub 34: Battery voltage
us 34: Battery voltage during last sat.
pulse
ver No. of program version
vx Voltage at channel x of A/D
97