CHAPTER 7 THE MODE-MENU
7.1 List of Menu points
The Menu points are organized in functional blocks. The starting
point of each block can be reached successively by simultaneous
pressing of MODE and SET. The frequently used positions MARK,
MEAS-INT and GAIN can be readily selected by going backwards
from position 1 using the ∨-key.
The below list shows the default settings, which can be reset at
any time by the command 36: RES. SETTINGS. The first points of
the functional blocks which can be quickly reached by the
MODE+SET command, are emphasized by boldface printing. The
double-key commands by which some of the menu points can be
quickly accessed are also listed.
Menu points: Quick access via:
1. Standard display MODE+START
2. AUTO-ZERO: 0(SET)
3. MEAS.LIGHT: ON (SET) MODE+ON
4. M.FREQ: LOW (SET)
5. ML-BURST: OFF(SET)
6. LIGHT AV15s:OFF(SET)
7. EXT.LIGHT-S:ON (SET)
8. LIGHT CALIB: (SET)
9. DISP.ILLUM.:OFF(SET)
10. AUTO-OFF: ON (SET)
11. AV. YIELD and ETR
12. ACT-LIGHT: OFF(SET)
13. ACT+YIELD: OFF(SET)
14. ACT-WIDTH 0:30 (SET)
15. ACT-INT: 5 (SET)
16. AL-FACT: 1:00 (SET)
17. LIGHT CURVE:OFF(SET) MODE+∧
15
To Next Page
Loading...
