CHAPTER 8 COMPONENTS OF THE MINI-PAM
software, data transfer (see 9) or for remote control of the MINI-
PAM functions via PC keyboard operation (see 13.4).
c) OUTPUT
A special cable is provided to connect the MINI-PAM analog
output to a chart recorder. The output signal can vary between 0 and
4 volt.
d) CHARGE
Together with the MINI-PAM the Battery Charger MINI-PAM/L
is delivered which connects to the CHARGE-input at the rear side of
the instrument. The charger can be used with line voltages of 100 to
240 V at 50-60 Hz. When used in the laboratory the charger can
remain permanently connected. A special cable (MINI-PAM/AK) is
available for connecting an external 12 V battery to the CHARGE-
input. While the MINI-PAM can be powered by this external battery,
it should be noted that the internal battery cannot
be recharged in this
way.
8.2 Fiberoptics MINI-PAM/F and Miniature Fiberoptics
MINI-PAM/F1
The fiberoptics are inserted into the corresponding adapter at the
rear side of the MINI-PAM. The active cross section of the standard
version MINI-PAM/F is 5.5 mm. A special version (MINI-PAM/F1)
with Ø 2 mm is also available, consisting of a single plastic fiber. In
the standard version, numerous 70 µm fibers are thoroughly
randomized over a 100 cm mixing pathway, such that a homogenous
field of illumination is created. A so-called 'Distance Clip' (see Fig.
5) is provided with the fiberoptics for convenient positioning of the
fiberoptics end-piece relative to the sample.
38
To Next Page
Loading...