Wang 5536 - Page 62

•
•
•
3402
5.2.2.3 CRT Chassis (Figure 5-6)
Removal:
o Unplug the 2 Molex connectors that connect the CRT Chassis to the
CPU/CRT PCA and the Power Supply.
o Scribe the positions of the CRT on the sides of the chassis and remove
remove the 3-1/4" hex-head screws and lock washers securing the CRT
chassis to the chassis base plate.
o Lift the CRT chassis out of the workstation.
Replacement:
o To replace the CRT chassis, reverse the above procedure •
Figure 5-6. Chassis Removal/Replacement
5-9