Wascomat EX618co - Mechanical Installation

24
Installation
C A
D
G
F
E
B
H
FRONT
5358
7
Mechanical installation
• Markanddrill2holes(ø8mm/5/16")about
40mm/19/16"deep(EX618-625)andø10
mm/3/8"and50mm/2"deep(EX630-660)in
thepositions.
 =positionoffeet
 =drillingpointsforexpanderbolts
• Themachinemustbeliftedinitsbaseframe.
• Placethemachineoverthetwodrilledholes
onthefoundation.
• Checkthatthemachineisinlevel,bothside-
to-sideandfronttoback.Adjustwiththefeet.
It is of utmost importance that the machine
level, from side to side as well as front to
rear. If the machine is not properly leveled,
it may result in out-of-balance without a
real out of balance in the drum.
• Mounttheexpanderboltsintheholesdril-
ledintheoor.Fitthewashersandnuts,and
tightenwell.
7
ininch A B C D E F G H
EX618 191/2 181/8 45/16 51/8 143/4 611/16 19/16 315/16
EX625 225/8 185/16 51/8 51/2 1715/16 75/16 13/8 33/4
EX630 25 195/16 55/16 67/8 201/4 711/16 23/8 45/16
EX645 281/8 217/16 415/16 81/16 237/16 75/16 23/8 41/2
EX660 311/8 243/16 41/2 71/16 263/8 67/8 23/8 41/2
EX675 357/16 295/8 23/8 71/16 263/8 67/8 23/8 43/4
inmm A B C D E F G H
EX618 495 460 110 130 375 170 40 100
EX625 575 465 130 140 455 185 35 95
EX630 635 490 135 175 515 195 60 110
EX645 715 545 125 205 595 185 60 115
EX660 790 615 115 180 670 175 60 115
EX675 900 755 60 180 670 175 60 120