7
NOTICE TO INSTALLER
Improper installation of this machine:
•Maycauseseriousdamagetothemachine.
•Mayresultinotherpropertydamage.
•Maycausepersonalinjury.
•Willvoidthemanufacturer'swarranty.
Improper fastening of this machine to its foundation, inferior foundation materials, an undersized founda-
tion, the use of fabricated steel bases not provided by Wascomat or its approved supplier(s), the use of an
improper type, number, or size of mounting bolts, or failure to use proper hardware on mounting bolts may
result in damage to the machine that will not be covered by the manufacturer's warranty.
Use of a steel base beneath this machine DRAMATICALLY INCREASES the mechanical stress placed on
the underlying concrete floor or foundation. This must be taken into consideration when employing a steel
base to raise the height of the machine.
Increase the manufacturer's recommended floor or foundation thickness requirements by at least three
inches (see installation manual) when using six-inch-high Wascomat steel bases to raise the machine's
height.
The use of steel bases more than six inches in height is NOT recommended. If installation requires a base
higher than six inches, contact Wascomat Technical Support at 516-371-0700 for advice.
Connection to line Voltage or over-current protection devices other than those specified on the data plate
may result in severe damage to machine components, and will void the manufacturer's warranty.
Refer to complete installation instructions provided in manuals accompanying the machine.
Contact Wascomat Technical Support at 516-371-0700 with any questions BEFORE installing this
machine. Damage resulting from inadequate installation materials or improper installation techni-
ques will void the manufacturer's warranty.
Safety
To Next Page
Loading...
