Wascomat EX618co - Installing the Machine

28
Installation
13
12
5463
5464
Installing the machine
To install the machine:
 • Removethetransportpackaging
 • Removethefrontpanel.
 • Removethemachinefromthetransportpallet
and locate it on the bolts.
Always lift the ma ch ine by the chassis, never
by the door or door handle.
 • Checkthatthemachineislevelandsteady
at all four corner mounting points. Adjust the
level by using stain less or galvanized steel
washers or shims be tween the machine and
the floor. The wash ers must be of a size to
cover the support sur face.
 • Fitthewashersandself-lockingnutssupplied
with the machine and tighten securely.
 • Totightenthenutswerecommendtouse
a rachet wrench, especially in the right rear
corner.
During the first several weeks of use, check and
tighten the nuts (as necessary) frequently. Conti-
nue to check them periodically, thereafter.
IMPORTANT NOTE:
Failure to closely follow the instructions provided
in this manual may result in severe damage to
the machine, and the risk of personal injury. The
manufacturer is not responsible for damage or
injury resulting from improper installation.
12
13
14
5951, 5952
14