Why is residual regenerant being delivered to service in Water Right Water Dispenser?
If residual regenerant is being delivered to service in your Water Right Water Dispenser, first check that the incoming water pressure is at least 25 psi. Then, verify that the injector size is correct for your application and replace it if necessary. Finally, inspect the drain line for any restrictions or debris and clean it.
General| Brand | Water Right |
|---|---|
| Model | Sanitizer Plus ASP1-1054 |
| Category | Water Dispenser |
| Language | English |
Warnings on piping, lubricants, sealants, and tool usage.
Lists the order of regeneration steps for system setup.
Step-by-step guide to setting the system's time.
Setting water hardness and days between regenerations.
How to interpret error codes and manage alarms.
Solutions for no display, incorrect time, or flashing time of day.
Problems with valve not regenerating automatically or using too much regenerant.
Solutions for the control valve not drawing regenerant.
Solutions for errors E3, E4 related to motor running too long.
Solutions for motor errors E1007, E107, E117, E109, E201.
Solutions for motor errors related to proper park position.
Solutions for errors E204 (leak) and E402 (power down).
Addresses control valve regenerating at the wrong time.
Solutions for errors E1, Err-1001, Err-101 related to motor sensing.
Troubleshooting when the control valve fails to auto-regenerate.
Solutions for errors E2, Err-1002, Err-102 related to motor stalling.
Details capacity, hardness, iron, pH, flow rates, and dimensions by model.
To Next Page