Watlow Ez-Zone PM8 - Chapter 8: Factory Page; Custom Setup and Security Settings

Watlow EZ-ZONE
®
PM Integrated Controller • 67 • Chapter 8 Factory Page
To go to the Factory Page from the Home Page,
press and hold both the Advance
‰
and Infinity ˆ
keys for six seconds.
• PresstheAdvanceKey
‰
to move through the
parameter prompts.
• PresstheUp¿ or Down ¯ keys to change the
parameter value.
• PresstheInfinityKeyˆ to return to the Home
Page.
Chapter 8: Factory Page
Navigating the Factory Page
Note:
Some of these menus and parameters may not appear, depending on the controller's options. See model number infor-
mation in the Appendix for more information. If there is only one instance of a menu, no submenus will appear.
8
[CUSt]
[FCty] Custom Setup Menu
[```1] to [``20]
[CUSt] Custom Setup
[`par] Parameter
[`iid] Instance ID
[`LoC]
[FCty] Security Setting Menu
[`LoC] Security Setting
[LoC;o] Operations Page
[LoC;P] Profiling Page
[pas;e] Password Enable
[RloC] Read Lock
[SLoC] Write Security
[loC;l] Locked Access Level
[roll] Rolling Password
[pas;u] User Password
[pas;a] Administrator Password
[ULoC]
[FCty] Security Setting Menu
[Code] Public Key
[Pass] Password
[diAg]
[FCty] Diagnostics Menu
[diAg] Diagnostics
[``Pn] Part Number
[`rEu] Software Revision
[S;bld] Software Build Number
[``Sn] Serial Number
[dAtE] Date of Manufacture
[USr;r] User Restore Settings
[USr;S] User Settings Save
[C;led] Communications LED Action
[2one] Zone Action
[Chan] Channel Action
[d;prs] Display Pairs
[`d;ti] Menu Display Timer
[`CAL]
[FCty] Calibration Menu
[```1] to [```2]
[`Cal] Calibration
[`Mu] Electrical Measurement
[ELi;o] Electrical Input Offset
[ELi;S] Electrical Input Slope
[ELo;o] Electrical Output Offset
[ELi;s] Electrical Output Slope