Auto-Zone Plus Section 4
Start-Up and Troubleshooting 4-45
3.3 Helpful Tips
• Position the damper to its mid position before applying power. Observe that the
damper drives in both directions during the calibration cycle following powerup.
• Observe the SCAN LED (Diagnostic Blink Codes) immediately following application
of power. The LED provides valuable information about the Zone Controller, for
more details see How It Works.
• Observe the REC LED (Communications LED), this LED will “flicker” anytime it
detects a request for data from this controllers address. If the REC LED does not
flicker you do not have communications, See the Communications Troubleshooting
section of this manual.
To Next Page
Loading...
