WattMaster Auto-Zone Plus - Page 28

Section 2
Installation and Wiring
Table of Figures
Figure 2-1: Plus System Overview.................................................................................2
Figure 2-2: Typical System Component Location..........................................................2
Figure 2-3: Auto-Zone Plus Zone Manager Dimensions ...............................................3
Figure 2-4: Auto-Zone Plus Zone Manager Components ..............................................4
Figure 2-5: Zone Manager Wiring..................................................................................5
Figure 2-6: Zone Manager Address Switch Setting .......................................................7
Figure 2-7: Communication Loop Wiring, Daisy-Chain Configuration ........................9
Figure 2-8: Round And Rectangular Bypass Dampers.................................................10
Figure 2-9: Bypass Damper Wiring..............................................................................12
Figure 2-10: Round And Rectangular Zone Dampers .................................................13
Figure 2-11: Zone Controller Components..................................................................15
Figure 2-12: Zone Controller Wiring...........................................................................17
Figure 2-13: Zone Controller Address Switch Settings...............................................18
Figure 2-14: Slaved Zone Controller Wiring...............................................................19
Figure 2-15: CV Controller With Backplate - Components ........................................20
Figure 2-16: Constant Volume Controller Wiring.......................................................21
Figure 2-17: CV Controller Address Switch Setting ...................................................23
Figure 2-18: Room Sensor Installation ........................................................................24
Figure 2-19: Room Sensor Wiring...............................................................................25
Figure 2-20: Supply or Return Air Sensor Installation................................................26
Figure 2-21: Outside Air Temperature Sensor.............................................................27
Figure 2-22: Duct Static Pressure Sensor ....................................................................28
Figure 2-23: Static Pressure Sensor Wiring.................................................................29
Figure 2-24: Auxiliary Relay Board Layout................................................................30
Figure 2-25: CommLink II Interface Dimensional Data .............................................32
Figure 2-26: CommLink Communications Loop Wiring ............................................33
Figure 2-27: CommLink Connection Wiring...............................................................34
Figure 2-28: System Manager Dimensional Data........................................................35
Figure 2-29: System Manager Wiring .........................................................................36
firealarmresources.com