18
EN
Cycle time setting
This menu is displayed only if parameter “Typ” (#26) is equal
to “bp”.
Use minus and plus keys to set cycle time value.
The setting is validated with validation key .
Default value: 10 minutes Other values: [10 15 30 45 60]
Proportional Band
This menu is displayed only if parameter “Typ” (#26) is equal
to “bp”.
Use minus and plus keys to set proportional band
value.
The setting is validated with validation key .
Default value: 2°C Value range: 2°C to 5°C
First parameter of H&C signal: width of death band
This menu is displayed only if parameter “Mod” (#07) is equal
to “Aut” or “Aut” is selected in “Reversible” mode menu.
This parameter corresponds to width of death band.
Use minus and plus keys to set value.
The setting is validated with validation key .
Default value: 1°C Value range: 0°C to 5°C by step of 0.5°C
Second parameter of H&C signal: time threshold
This menu is displayed only if parameter “Mod” (#07) is equal
to “Aut” or “Aut” is selected in “Reversible” mode menu.
This parameter corresponds to a time threshold.
Use minus and plus keys to set value. The setting is
validated with validation key .
Default value: 1H Other values: no, 30’, 2H, 3H, 4H and 5H
Minimum value of setting range of the set point
temperature
Default value: 5.0°C Value range: 5.0°C to 15.0°C
Maximum value of setting range of the set point tem-
perature
Default value: 30.0°C Value range: 20.0°C to 37.0°C
To Next Page
Loading...
