Installation guide
Please install WaveShark Foil in a clean and dry place by the following steps or the tutorial videos in
the WaveShark app.
Connect board and mast
Before surng, please connect the board and mast in accordance with the following steps
.
1) Place the board on a at surface with the bottom facing upside;
2) Move the mast close to the base, connect the waterproof connector of the mast to the waterproof
plug of the driver box, and screw them tightly;
Caution:
When installing the mast, be sure to keep the mast close to the base. While installing
the waterproof connector, do not use force to pull the wire. When removing the mast,
tilt the mast rst and make sure to detach the waterproof connector before removing
the mast. Forcefully pulling the wire will cause damage to the equipment or water leakage.
3) Fix the mast in the installation position on the board using M8 screws, and make sure the mast
bottom tightly touches the board' bottom, leaving no margin of slack.
Connect wing set and wing pole
Before using the product, please connect the wing set and wing pole in accordance with the following
steps.The wing set covers three types, including Cruiser wing, Sport wing, and Race wing. Actual wing
choice depends on your specic conguration.
The tool kits used to connect the cruiser/sport wing and the wing pole are the same, while the tool kit used
to install the race wing is different from them.
To Next Page
Loading...