EN
Transportation
1. Separate the wing, mast and board before transportation;
2.Store the battery and board in spearate storage bags. Before transportation, discharge the
battery until the battery level is below 30%.
Warning:
The battery of the board is classied as a Class 9 dangerous object. Please transport
the battery in strict accordance with Regulations on Safe Transport of Class 9 Dangerous
objects. It is illegal and dangerous to falsely declare batteries as common goods for
transport. Please follow the requirements of the shipping company and provide
the MSDS certificate that has been provided with the surfboard.
Storage
•
How to store the battery
1. Remove the battery from the board after each use, and store it in a safe storage environment;
2. The battery should be stored in a temperature range of 0
℃
- 25
℃
.
Keep the product away from re
and high temperature environments, such as direct sunlight, inside the car on a hot day, and near a
re or heating source to avoid battery overheating, which would shorten the battery life or might
even result in an accident;
3. The storage environment should be kept cool and dry, and not be exposed to the sun or rain;
4. For storage of the battery over a long period (over 30 days), please charge or discharge it to maintain
45%-50% of battery level before storage to keep the battery active. Otherwise, such long-term storage
may lead to battery damage;
5. During storage, the battery shall be charged every three months to maintin 45%-50% of battery
level. Long-term storage at a low battery (lower than 5%) will cause battery damage due to over-
discharge, or might even reduce the lifespan of battery.
•
How to store the board
1. Store the board in a cool and dry place after each use;
2. Do not stack the board with other objects during storage. Otherwise, it will cause damage to the board.
Maintenance and repair
In order to prolong the lifespan of board and battery, please maintain and repair them by the
following steps.
•
Regular maintenance
1. Check the board and battery regularly for any collision or damage. If there is damage or water
leakage, please contact the professional maintenance staff or call the WaveShark technical support for
assistance;
2. Rinse the power unit, battery connector, battery latch and screws for 2 to 3 minutes every week. Then
brush the battery connector clean to ensure there is no white scale or green rust in every corner;
3. After the board is dry, apply WD40 to the battery connector, battery latch and screws;
4. Apply rust remover to the power unit, battery connector, battery latches, and screws regularly to
prevent corrosion;
•
Mechanical seal maintenance
When notications occur on the remote controller and app to remind you to maintain the mechanical
seal, please take actions by the Mechanical Seal Maintenance Instructions on the ofcial website or
watch the tutorial video by tapping Device Manager > Connect in the app, or consult the WaveShark
technical support.
To Next Page
Loading...