WaveShark Foil - Post Surfing Procedures; Cleaning the Equipment

27
3. The lifting force of the hydrofoil will push the board away from the water. If the board tends to turn
up, shift your weight forward, so that the board always keeps in parallel to the water;
4. To make a turn, rst look in the direction of the turn to check whether there is any obstacle. If it is
safe to do so, lean slowly towards the direction of your turn and return to the middle position after
the turn is nished;
5. When you lose control over your board during ight, please try to fall to the side of the board, and
keep away from the wing and propeller.
Warning:
1) When falling into the water, the operator shall immediately release the accelerator trigger of the
remote controller, which will cut off the propulsion power and prevent the equipment from hitting
other swimmers or boats.
2) Always pay attention to the battery level indicator and return notication during use for a safe return to
the shore.
3) Flying and making a turn require serious parctice and a steady control of the board. Please take the
time to learn how to operate the board. Be very careful during operation.
Post surng
Please operate by the following steps after each ride.
Clean
1. Disable the safe lock by pressing the Power button on the remote controller twice, and turn off the
board and remote controller normally as usual;
2. Take the board out of the water with the tail down. Keep tilted until the water completely dropped out
of the board;
Caution:
If the boad is waterlogged, please remove the water using the water drain valve.
3. Unlock the four battery latches, remove the battery and check whether the battery connector is dry.
If it is wet on the surface, rinse the battery connector with clean fresh water and dry it off in the sun
or with a hair dryer or blower;
4. Put the dry battery in its special storage bag and zip up;
5. Keep the board tilted and carefully rinse it with clean fresh water;
Caution:
1) Do not rinse the board with a water cannon.
2) Mainly rinse such board parts as power unit, battery connector, battery latches, screws and battery
compartment.
6. Dry off the board in the sun, or wipe it dry with clean cloth;
7. After drying the board, separate the wing, mast and board. Place the board in its special storage
bag and zip up.