Surf preparation
1. Perform power-on check;
1) Turn on the board by pressing the Power button, check the battery level and ensure the board is
sufciently charged;
2) Turn on the remote controller by pressing the Power button for 3 seconds, check the battery level
and ensure the remote controller is sufciently charged;
3) Connect to the board following the onscreen instructions on the remote controller;
4) Gently touch the trigger of remote controller to ensure the propeller works normally;
Warning:
Do not spin the propeller over 5 seconds outside the water. Otherwise, the sealing system
of the propulsion system may be damaged due to overheating.
Danger:
Do not touch the moving parts of the pump-jet propulsion system during the power-on
check. Otherwise, this may lead to personal injury.
5) Turn off the board and remote controller.
2. Find an open water area, and make sure that the water depth is more than 1.5 meters. Do not use
this product in crowded waters. Make sure to wear a life jacket, hemlet, and other protective equipment
before entering the water;
3. Install the battery on a dry, sand-free site, and ensure the battery is locked tightly;
4. Move the board to water that provides an appropriate depth while making sure to turn off the remote
controller to prevent the accelerator from being triggered by mistake;
5. Turn on the board by pressing the Power button;
6. Turn on the remote controller by pressing the Power button for 3 seconds;
7. Connect the board and remote controller, and activate the safe lock by pulling the trigger. Then enable
the safe lock by pressing the Power button twice on the remote controller.
Caution:
After the safe lock is enabled, the operation of turning off the board manually will not
work, which effectively prevents users from shutting down the board by mistake while
surng. After each ride, disable the safe lock by pressing the Power button twice on
the remote controller, and turn off the board manually as usual.
8. Wear the wristband;
9. Switch the gear with the buttons on the remote controller to select the appropriate gear. Gear 1 or
gear 2 are recommended for beginners.
Caution:
Please gently press the trigger to control the accelerator. Do not press the accelerator
all the way down with high speed.
Start surng
Beginners
1. Grasp the battery grip with two hands, leap up to the board while pressing it down, climb on top of
the board, adjust your body posture, and keep your balance;
2. Gently pull the trigger of the remote controller to move the board forward. When the head of the
board tends to move up, climb slowly to the front of the board and keep the trigger pressed at the
same level;
3. Continue pulling the trigger to accelerate when the board maintain balance. If the head of the board
To Next Page
Loading...