46
Part No. 920559 Rev H November 2008
5.3 Dispenser Cleaning Procedures, continued
• Level Three
The third step, only for the most stubborn of stains, is to use mildly abrasive cleaners, such
as Soft Scrub. Afterwards, be sure to wipe down the dispenser with a clean cloth and clean
water.
Periodic waxing of the dispenser surfaces is essential to maintain the original finish and
inhibit corrosion. Painted surfaces should be waxed with an automotive wax or polish.
GLASS AND CLEAR PLASTIC SURFACES
Glass and clear plastic surfaces can be cleaned as in the first step. A household glass
cleaner, such as Windex, can also be used. It is important that nothing abrasive is used on
these surfaces. Please use extra caution during levels two and three cleaning to avoid con-
tact with display windows. Should the more aggressive cleaners come in contact with the
displays, please wash with water immediately.
STAINLESS STEEL SURFACES
Exposure to contaminants can cause a discoloration of the stainless steel panels. If the dis-
coloration persists after washing as instructed above, the use of an abrasive powder
cleaner is very effective in restoring the original shine.
Two cleaners in particular are very effective and practical to use on these surfaces: Zud
Heavy Duty Cleaner and Bar Keepers Friend. They can be found in most hardware/grocery
stores. Follow the manufacturers' instructions for use and always rub in the direction of the
brush finish to prevent scratching the stainless steel.
NOTE:It is important to wipe down the dispenser with a clean cloth and clear water after
every cleaning.
Periodic waxing of the dispenser surfaces is essential to maintain the original finish and
inhibit corrosion. Stainless steel surfaces should be polished with a non-abrasive silicone
wax.
Note: No chlorine based cleaners can be used on the stainless steel, especially, if the dis-
penser is located in a marina environment.
To Next Page
Loading...
