73
November 2008 Part No. 920559 Rev H
APPENDIX C
LOCAL AUTHORIZE / STAND-ALONE OPERATION
When the dispenser is not equipped with a Local Authorize Switch, the jumper (J7) shown below must be in
place to enable Stand-alone operation.
At new dispenser Startups, after product lines have been purged and dispenser operations checked, once the dis-
penser is switched over to control system operation, the jumper should be removed as an extra security measure.
If stand-alone operation is required in the future, the jumper will have to be re-installed.
Local
AUTH
Jumper
J7
Unit Price Display Board
To Next Page
Loading...
