58
Part No. 920559 Rev H November 2008
Ovation iX CAT Self Test Procedure, continued
8. Press Yes or No at the “Want to Configure DM” prompt.
If No is pressed, the self-test ends and the screen prompt sequence in step12 occurs.
If Yes is pressed, the Orientation (VGA) or Contrast (QVGA) screen is displayed, see step 9.
9. Press Cancel or press the appropriate #1, #2, #5 or #6 softkeys to change screen Orientation
(VGA) or Contrast (QVGA) and press Cancel.
10. Press Yes or No at the “Softkey Enable Mode to POS” screen.
11. Enter the dispenser Fueling Point number, via the keypad, and press Cancel at the prompt
“Please enter F. P. press Cancel when done”.
Note: IP Address is assigned automatically (via xml file) when the F.P. number is entered.
At this point, the self-test ends, a configuration report will print, and the system will reboot.
12. After the screen prompt Dispenser Manager Starts is displayed for several seconds, the
One Moment Please, Dispenser Manager Starts, and Dispenser Offline prompts are
displayed briefly, and then the screen will go to the online prompt screen, or to the offline
prompt if the POS is offline.
This completes the self-test procedure.
To Next Page
Loading...
