wayscral TAKEAWAY E-50 User Manual (English)

Questions and Answers:

A
Andrew RoachAug 5, 2025
What to do if my Wayscral Bicycle engine doesn't provide pedal assistance?
- M
  Mr. Joseph MurphyAug 5, 2025
  If your Wayscral Bicycle's engine isn't assisting after you switch on the battery, there might be several reasons. First, ensure the battery is charged. Then: * Check the engine cable connection for looseness. * Make sure the brake lever is fully released. * Inspect the battery fuse; if it's blown, get a replacement from your retailer. * Adjust the speed sensor distance to be within 3 mm of the magnetic tape. * Confirm the sensor and controller are correctly connected.
D
Douglas FuentesAug 10, 2025
Why is my Wayscral Bicycle battery life so short?
- N
  Nicholas StephensonAug 10, 2025
  If you notice that your Wayscral Bicycle's battery life is shorter than expected, consider these factors. Battery performance is affected by user weight, baggage, wind, road type, and braking habits. Also: 1. Ensure the battery is fully charged according to the instructions. 2. If it's cold (below 0°C), store the battery indoors. 3. Hills, headwinds, and poor road conditions can reduce battery life, but this should improve with better conditions. 4. Maintain a tyre pressure of 3.1 bar. 5. Frequent stops and starts impact battery life; this will improve with better usage conditions. 6. Regularly charge the battery as instructed. If problems persist, consult a professional.
B
Betty WilsonAug 16, 2025
Why is the LED still red after charging my wayscral TAKEAWAY E-50 Bicycle for 5 hours?
- S
  Sherry BrownAug 17, 2025
  If the charge LED on your Wayscral Bicycle remains red after 4-5 hours of charging, it could be due to a few reasons. Ensure you're charging the battery as instructed to prevent damage. The possible causes are: * Ambient temperature is too high (40°C or higher). * Ambient temperature is too low (0°C or lower). * The bicycle wasn't charged after use, worsening the charge depletion. * The output voltage is too low (less than 100 V). To resolve this: * Charge below 40°C and follow instructions. * Charge indoors if it's too cold. * Maintain the battery correctly. * Use a voltage of at least 100 V for charging.
S
Sara SimmonsAug 22, 2025
How to fix charging LEDs not lighting up on wayscral TAKEAWAY E-50 Bicycle?
- M
  Michael SalinasAug 22, 2025
  If the charging LEDs on your Wayscral Bicycle don't light up when you connect the charger, it could be due to: 1. A problem with the electrical outlet. 2. Poor contact between the charger and the outlet. 3. Low temperature. Try these solutions: 1. Check and repair the outlet. 2. Ensure the plug is fully inserted. 3. Charge indoors.
S
Sierra BaileyAug 29, 2025
What to do if the red LED immediately turns green on my wayscral TAKEAWAY E-50 when charging?
- B
  benjaminwhiteAug 29, 2025
  If the red LED immediately turns green when charging your Wayscral Bicycle, it could indicate that the battery is already fully charged. However, if you know that the battery is not charged, then it may be a sign of a defective battery or charger.