23
11 Menu item: System
11.1 General information
UTC time for housekeeping reboot – Time required for automatic restart of the charging station
The Webasto Live has an automatic restart function for when the charging station has not restarted within the last 30 days. This param-
eter can be used to configure the time for the automatic restart according to UTC Standard Time. The restart is only executed after 30
days if no vehicle has been connected to the charging station. Enter the desired time in the range of 0-23 (full hours) into the text field.
Default Value: 1
Factory Reset by RFID – Resetting to factory settings using RFID media
The Webasto Live has the function for resetting all configurations made back to the factory settings. This is done, for example, using the
number of the RFID media that is supplied and stored here and is held to the RFID reader for at least 120 seconds. An acoustic signal
sounds after this time has elapsed. The numbers of the two RFID media supplied with the charging station are stored by default. Alter-
natively, other RFID media can also be entered as described below.
NOTE
Up to two numbers of RFID media for a reset to factory
settings can be stored.
NOTE
Webasto recommends the use of the two supplied
RFID media.
1. Enter the number of the RFID media in the text field that you would like to use for the reset to factory settings.
NOTE
Enter the number of the RFID media in digits and in
lower-case letters.
2. Click on "Save" in the bottom menu bar.
Log Level – Specifying the desired logging level for error cases
The Webasto Live has automated logging of error cases. This can help the remote support team when rectifying a fault when it occurs.
This menu can be used to select the scope of error logging.
Default Value: LOG_LEVEL_DBG
LED Brightness – Adjusting the brightness of the integrated LED status bar
The brightness of the LED status bar can be adjusted in 1% steps using this menu item.
Default Value: 100
NOTE
Complete deactivation of the LED status bar is not pos-
sible because it fulfills a security relevant function. Error
messages present in the charging station are still dis-
played with 100% brightness even after changing the
parameter and displayed with the corresponding light
scheme in order to inform the user about anerror.
Enable Sound – Switching the audio output of the charging station on and off
The "Enable Sound" menu item is used to switch the integrated sound module of the charging station on and off. Warnings are always
signaled.
Default Value: On
11.2 Password – Login password for the web interface
Change the login password for accessing the web interface and save it by clicking on "Save" in the bottom menu bar.
NOTE
The login password for the charging station can be
changed only after defining the RFID media for factory
settings.
NOTE
After the reset to factory settings („11.1 General infor-
mation“ on page 23), reset the login password again
to the password specified in the supplied manual.
To Next Page
Loading...
Need help?
General
