13
Select "Auto (DHCP client)" if you would like to integrate the charging station into your home network. Your wireless router automati-
cally transfers the necessary settings to the Webasto Live.
Select "Manual config" to integrate it into an existing network which requires a fixed assignment of parameters. Fill the fields shown
with the network parameters used in the destination network accordingly.
7.4 Wifi Configuration Hotspot
When delivered, the Webasto Live has an activated and encrypted WLAN hot spot. This hot spot is only suitable for configuring the
Webasto Live and cannot be used to access the internet.
NOTE
Webasto recommends that you adjust the following
parameters of the configuration hot spot as the final
step in the initial start-up.
NOTE
If currently accessing the configuration interface via the
configuration hot spot, the changes to the parameters
once successfully saved must also be saved for the
wireless connection on the configuration PC, as access
to the interface is otherwise not possible.
Hotspot enabled – Deactivating the Webasto Live configuration hot spot
This parameter can be used to deactivate the Webasto Live configuration hot spot. Set the parameter to "Off" to deactivate the hot
spot.
NOTE
If the configuration hot spot has been deactivated, the
configuration interface can only be accessed via the
configured WLAN or LAN connection or the USB cable.
(see "Accessing the configuration interface").
NOTE
Webasto recommends changing the hot spot password
during the initial configuration or deactivating the hot
spot so that unauthorized persons cannot gain access.
Hotspot SSID – WLAN-name (SSID) of the Webasto Live configuration hot spot
An individual network name can be assigned so that the associated Webasto Live configuration hot spot can be identified. When deliv-
ered, the serial number of the Webasto Live is registered as the WLAN name to enable a unique assignment of the configuration hot
spot.
Encryption – Encryption process of the Webasto Live configuration hot spot
Select a desired encryption process for the configuration hotspot.
NOTE
Webasto recommends that the configuration hotspot
be encrypted using "WPA2-PSK CCMP"
Hotspot password - Password for the Webasto Live configuration hot spot
Specify the network password for the configuration hot spot of the Webasto Live.
NOTE
Webasto recommends the use of a unique password
with at least eight characters.
Hotspot subnet
This parameter is used to specify the IP address range in which the hot spot is located.
Hotspot netmask
This parameter is used to specify the IP net mask in which the hotspot is located.
DHCP server enabled
This parameter is used to specify if the Webasto Live charging station should function as a DHCP server for the hot spot. This value
should be deactivated if you would like to connect multiple charging stations using this hot spot but would like to assign the IP address-
es of the other devices manually.
DHCP server gateway and DHCP server DNS do not currently need to be filled
To Next Page
Loading...
