11
6 Initial start-up
Please configure the following parameters before charging with the Webasto Live for the first time as this will ensure that it can be used
properly. To make the initial configuration, connect to the Webasto Live via the configuration hot spot or USB. (see chapter „3 Access-
ing the configuration interface“ on page 7)
Refer to the description of the individual points when configuring the parameters. Follow the order of the parameters and cross off the
respective parameter in the check list after completing the configuration. The check list can be found under „13.3 Check list for config-
uring a charging station“ on page 27.
To Next Page
Loading...
