Weber 3600 User Manual

WWW.WEBER.COM
®
7
LPG CYLINDER INSTALLATION AND REMOVAL
FUELING YOUR
BARBECUE
Before using your grill for the
first time, you need to obtain
an LPG cylinder. New LPG
cylinders can be purchased full;
empty LPG cylinders can be
refilled or exchanged. You may
choose to purchase a spare
LPG cylinder so that you don't
run out of fuel in the middle of
cooking a meal.
The minimum LPG cylinder capacity for this barbecue is 9kg.
m DANGER
NEVER store a spare LPG cylinder under
or near Weber
®
gas appliances. NEVER fill
the LPG cylinder beyond 80% full. Failure to
follow these statements exactly may result
in a fire causing death or serious injury.
Prepare Barbecue for LPG Cylinder Installation
A) Check that BOTH burner control knobs are in the
off ( ) position (1). Your barbecue was shipped with
burner control knobs in the off ( ) position, but you
should check to be sure that they are turned off.
Check by pushing in and turning knobs clockwise. If
they do not turn, they are off. If they do turn, continue
turning them clockwise until they stop; then they are
off.
Install the LPG Cylinder
A) Install the LPG Cylinder upright on a level surface. Do
not place the LPG cylinder on its side.
B) Turn the LPG cylinder so the opening of the valve is
facing the front or side of the enclosure (2).
m WARNING: Make sure that the LPG
cylinder valve is closed. Close by turning
valve clockwise.
Connect the Regulator / Hose to the LPG Cylinder
A) Connect the hose and the regulator to the LPG
cylinder by screwing the POL coupling into the LPG
cylinder valve, turning anticlockwise, or to the left (3).
Hand-tighten only. The regulator vent hole should be
pointing down.
m WARNING: The regulator has left hand
screw threads. It tightens by turning
anticlockwise.
m WARNING: Do not use a wrench to
tighten the connection. Using a wrench
could damage the regulator coupling
and could cause a leak.
m WARNING: No sealant is required on the
POL fitting. Do not use pipe dope, tape or
any other sealant on the POL fitting or
LPG cylinder.
REMOVING THE LPG CYLINDER FOR
REFILLING OR REPLACEMENT
The amount of cooking time a full LPG cylinder will last
varies depending on use. You do not have to run out of
fuel before you can refill the LPG cylinder. In fact, we
recommend that you refill the LPG cylinder before it is
completely empty.
Removal of the LPG Cylinder
A) Close LPG cylinder valve (turn clockwise) (4).
B) Unscrew regulator by turning POL coupling clockwise
by hand (5).
C) Remove LPG cylinder from gas supply enclosure.
FILLING THE LPG CYLINDER
m WARNING: We recommend that your
LPG cylinder be filled at an authorized
gas supplier, by a qualified attendant,
who fills the LPG cylinder by weight.
IMPROPER FILLING IS DANGEROUS.
NOTE: Be certain LPG cylinder is purged of trapped air prior
to first filling. Your gas supplier is equipped to do this.
1
2
3
54

Weber 3600 Specifications

General

Brand	Weber
Model	3600
Category	Grill
Language	English