WWW.WEBER.COM
®
19
ROUTINE MAINTENANCE
IGNITION SYSTEM OPERATION
The igniter supplies a spark to the igniter electrode
assembly. Whether you are performing routine
maintenance or a troubleshooting check on the ignition
system, read the following to keep your ignition system
working properly.
m WARNING: All gas controls and supply
valves should be in the OFF position.
If the igniter fails to ignite your Q
®
barbecue, you will need
to pinpoint where the problem is occurring: with the gas
flow or with the ignition system. Begin by attempting to
match light your burner. Refer to “BURNER IGNITION—
Lighting with a Match.” If match lighting is successful, the
problem lies in the ignition system.
MAINTAINING THE ELECTRONIC IGNITION
SYSTEM
• Verify that the AAA battery (alkaline only) is in good
condition and is installed correctly (1). Some batteries
have a plastic protective wrap around them. This
plastic must be removed before installing battery (2).
Do not confuse this plastic with the battery label.
• Open the catch pan door on the front of the cabinet to
view the igniter module inside (3).
• Make sure that both igniter wires are properly
attached to the igniter module. Black wire to black
terminal (4), white wire to white terminal (5).
• Make sure the electronic igniter button is working by
listening for clicking and looking for sparks at burner.
• Close the catch pan door.
If the electronic ignition system still fails to ignite,
contact the Customer Service Representative in your
area using the contact information on our web site. Log
onto www.weber.com.
2
AAA
1
5
4
3
To Next Page
Loading...
Need help?
General
