Weber 3600 User Manual

6 WWW.WEBER.COM
®
REGULATOR CONNECTIONS
Your Weber
®
gas barbecue is equipped with a pressure
regulator, which is a device to control and maintain
uniform gas pressure as gas is released from the LPG
cylinder. Each Weber
®
pressure regulator is designed for
vapor withdrawal.
• The pressure regulator supplied with the Weber
®
gas barbecue must be used. This regulator is set for
2.75kPa.
• Replacement pressure regulator and hose
assemblies must be those specified by Weber-
Stephen Products LLC.
• Be sure the regulator is mounted with the small vent
hole pointed downward so that it will not collect water.
This vent should be free of dirt, grease, bugs, etc.
m WARNING: Replacement LPG cylinders
must match the regulator connection
supplied with this Weber
®
gas appliance.
WHAT IS A REGULATOR?
Your Weber
®
gas barbecue
is equipped with a pressure
regulator, which is a device
to control and maintain
uniform gas pressure as gas
is released from the LPG
cylinder.
REPLACEMENT HOSE,
REGULATOR AND VALVE ASSEMBLY
m IMPORTANT NOTICE:
We recommend that you replace the
gas hose assembly on your Weber
®
gas barbecue every five years. Some
countries may have requirements
that the gas hose be replaced within
less than five years, in which case
that country’s requirement would take
precedence.
For replacement hose, regulator,
and valve assemblies, contact the
Customer Service Representative
in your area using the contact
information on our web site.
Log on to www.weber.com.
POL CONNECTION
3
4
2
1
5
1 Valve handwheel – close clockwise
2 Hose
3 Regulator
4 POL connection – tighten anticlockwise
5 Regulator vent hole - point hole downward
IMPORTANT INFORMATION ABOUT LPG CONNECTIONS

Weber 3600 Specifications

General

Brand	Weber
Model	3600
Category	Grill
Language	English