56445 02/25/11
AA
1
HOSE FROM GAS SOURCE DiSCOnnECtiOn
FOR LP UNITS:
A) Unscrew regulator coupling from tank valve; turn counter-clockwise, or to
the left (1).
m WARNING: Do not use a wrench to loosen connection. Using
a wrench could damage regulator coupling and could cause a
leak.
1
FOR NG UNITS:
A) Slide back collar of the
quick-disconnect to remove
hose from gas source.
THIS PROCEDURE SHOULD ONLY BE PERFORMED BY AN AUTHORIZED
WEBER-STEPHEN PRODUCTS LLC SERVICE TECHNICIAN
m BEFORE STARTING: Make sure lid is
closed and casters are locked to prevent
grill from moving.
NOTE: Grills illustrated may have slight differences than model purchased.
m WARNING: GENUINE WEBER-STEPHEN REPLACEMENT PARTS MUST BE USED FOR ANY REPAIR OR REPLACEMENT.
YOUR ACTIONS, IF YOU FAIL TO FOLLOW THIS PRODUCT WARNING, MAY CAUSE A FIRE, AN EXPLOSION, OR
STRUCTURAL FAILURE RESULTING IN SERIOUS PERSONAL INJURY OR DEATH AS WELL AS DAMAGE TO PROPERTY.
(WILL VOID ALL WARRANTY PROTECTION.)
m
DANGER: BEFORE PERFORMING ANY WORK MAKE SURE THE GAS SUPPLY IS TURNED OFF AT THE SOURCE.
FAILURE TO FOLLOW DANGERS, WARNINGS AND CAUTIONS CONTAINED IN THIS INSTRUCTION SHEET MAY CAUSE A
FIRE OR AN EXPLOSION RESULTING IN SERIOUS PERSONAL INJURY OR DEATH AS WELL AS DAMAGE TO PROPERTY.
BURNER TUBE
REPLACEMENT INSTRUCTIONS
BURnER tUBE
REplACEMEnt
iGnitER
WiRE ClipS
REplACEMEnt
To Next Page
