16
MAIN BURNER IGNITION & USAGE
MAIN BURNER IGNITION
m DANGER
Failure to open the lid while igniting the grill’s burners, or not
waiting five minutes to allow the gas to clear if the grill does
not light, may result in an explosive flare-up, which can cause
serious bodily injury or death.
Main Burner Snap Ignition
NOTE: Each control knob snap igniter creates a spark from the igniter electrode to the burner
lighting tube. You generate the energy for the spark by pushing in the control knob and turning
to START/HI. This will ignite each individual burner.
A) Open the lid (1).
B) Make sure all burner control knobs are turned o (2). (Push control knob in and turn
clockwise to ensure that it is in the OFF position.)
m WARNING: The burner control knobs must be in the OFF position
before turning on the liquid propane cylinder tank valve.
C) Turn on the cylinder valve using one of the appropriate options based on your cylinder
and regulator type (3).
m WARNING: Do not lean over the open grill.
D) Push the control knob in and turn to START/HI until you hear the igniter snap -
continue to hold control knob in for two seconds. This action will spark the igniter, the
burner lighting tube and then the main burner (4).
E) Check that the burner is lit by looking through the cooking grates. You should see a
flame (5). If burner does not light at the first attempt, push control knob in and turn to
OFF. Repeat lighting procedure a second time.
m WARNING: If the burner still does not light, turn the burner
control knob to OFF and wait five minutes to let the gas clear
before you try again or try to light with a match.
◆
TO EXTINGUISH
Push in and turn each burner control knob clockwise to OFF position. Turn gas supply o
at the source.
◆
OFF START/HI MEDIUM LOW
The grills illustrated in this
Owner’s Guide may vary slightly
from the model purchased.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
