WWW.WEBER.COM
9
GAS INSTRUCTIONS
CONNECTING THE LPG CYLINDER
m WARNING: Make sure that the LPG cylinder or regulator valve is
closed.
A) Connect LPG cylinder.
Some regulators push ON to connect, and pull OFF to disconnect, others have a nut
that has a left-hand thread that connects to the cylinder valve. Follow one of the
specific regulator connection instructions illustrated based on your regulator type.
a) Screw regulator fitting onto tank turning clockwise (1). Position the regulator so
that the vent hole (2) faces down.
b) Screw regulator fitting onto tank turning anti-clockwise (3) (4).
c) Turn regulator lever (5) clockwise to the o position. Push regulator down on tank
valve until regulator snaps into position (6).
d) Make sure regulator lever is in the o position. Slide the collar of the regulator up
(7) (9). Push the regulator down onto the tank valve and maintain pressure. Slide
collar closed (8) (10). If regulator does not lock, repeat procedure.
◆
REPLACEMENT HOSE, REGULATOR AND VALVE ASSEMBLY
m IMPORTANT NOTICE: We recommend that you replace the gas
hose assembly on your gas grill every 5 years. Some countries
may have requirements that the gas hose be replaced within
less than 5 years, in which case that country’s requirement
would take precedence.
For replacement hose, regulator, and valve assemblies,
contact the Customer Service Representative in your area
using the contact information on our web site.
Log on to www.weber.com.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
