15
Combing Mode: when the nozzle is not printed, the way of the nozzle's running, including off, all
and no skin, it is usually set by default.
Start layers at same position: that is to change the accuracy of the model in the same plane, and it is
generally set the default.
Layer start position X（mm）：that is, you want to change the X axis coordinates of the position of the
model layer.
Layer start position Y（mm）：that is, you want to change the Y axis coordinates of the position of the
model layer.
3.2.8、"Machine" interface：
WEEDO series 3D printers include single nozzle and double nozzle machines. At present, the WEEDO
series 3D printers use the 0.4mm diameter nozzle.
3.2.9、“Line Width” interface
To Next Page
Loading...
