33
After that, heat the nozzle to 200 degrees, fix the nozzle with a tool such as a pliers, and use a
1.5mm wrench to clear it until the blocked wire is completely cleaned.
Then install the nozzle and fix it with the screw.
Note：after clean the nozzle, need to re-calibrate the platform level before printing.
6.1.2 Replacing the tape of the glass plate
Check the surface of tape on the glass plate for wear and unevenness; if the sticker has been worn,
it must be replaced to ensure that the model can be firmly attached to the heating plate.
Maintenance method: start with finding a roll of tape included in the accessory box
To Next Page
Loading...
