Need help?Do you have a question about the WEEDO X40 and is the answer not in the manual?
Overview of the WEEDO X40 3D Printer with labeled components.
How to operate the printer's touch screen interface and navigate between screens.
Description of the main interface icons and status bar information.
Steps to select a G-code file from TF Card or WIFI Disk for printing.
Details of the printing interface, including status, controls, and options like Quit and Pause.
How to connect the printer to a Wi-Fi network.
How to select the display language for the printer interface.
View detailed information about the printer's hardware and firmware.
Configure automatic shutdown settings for the printer after printing.
Enable or disable the filament runout sensor to pause printing.
Enable or disable the Power-On Self-Test (POST) function.
Configure different power saving modes for the printer.
Instructions for updating the printer's firmware.
Manage firmware parameters, save, load, and reset settings.
Load filament into the nozzle for printing.
Retract filament from the nozzle.
Preheat the nozzle and bed to desired temperatures.
Manually move the printer axes (X, Y, Z) for positioning.
Adjust the flatness of the build platform relative to the nozzle.
Fine-tune the gap between the nozzle and the build platform for optimal adhesion.
Adjust the height of the proximity switch for accurate Z-axis homing.
Calibrate the alignment between dual nozzles for accurate printing.
Step-by-step instructions for installing the WiiBuilder slicing software on a PC.
Initial setup and configuration of the WiiBuilder software for the printer.
General| Brand | WEEDO |
|---|---|
| Model | X40 |
| Category | 3D Printers |
| Language | English |
To Next Page
