2
• Use only in a well-ventilated area. Do not use in close, confined spaces.
• Take care when using a scraper to remove a model. Never direct the scraper towards your
fingers or body.
• The printer is designed to operate with an ambient temperature ranging from +41°F
(+5°C) to +104°F (+40°C). Printing outside these limits may result in low quality prints.
• Use eye protection when cleaning or sanding the printed models to avoid getting small
particles in your eyes.
2.INTRODUCTION
Thank you for purchasing this X40 3D Printer! This printer uses the FFF (Fused Filament
Fabrication) method of printing. It features a metal frame, heated build platform. It can print
1.75mm ABS, PLA, metal fill, wood fill, and other filament types with melting points below
250°C. The machine with Independent Dual Extruders can print at a speed up to150mm/s and
300x300x400mm printing area. It can print from sliced g-code files stored on a micro SD™ card
or from our App. It supports auto leveling, automatic shut-down, with a 4.3-inch touch screen, a
removable and a heated build plate.
3.FEATURES
• Supports auto leveling
• Includes a heated, removable, build platform
• Can print using APP or from a sliced g-code file on a SD card
• Supports ABS, PLA, metal fill, wood fill, and other filament types with melting points
below 260°C
• 300 x 300 x 400 mm print area
• Can print at speeds up to 80mm/sec.
• Includes WiiBuilder slicing software
• Includes 4GB TF card
• Half assembled
• Support duplicate printing and mirror printing
To Next Page
Loading...
