14
Wegaconcept
User manual
9.2 Programming hot water doses
To program the hot water doses, proceed as fol-
lows:
place the cup under •
the hot water nozzle
(12);
press and hold down •
the "PROG/STOP" key
on the left push-but-
ton panel until all dose
key LEDs switch on;
press the hot water delivery key •
;
when the desired dose has been reached, con rm •
by pressing the hot water key
again;
repeat the operation for the other dose button;•
upon completion of programming, press the •
“PROG/STOP” key.
12
9 Programming doses
9.1 Programming co ee doses
To program the dose keys, proceed as follows:
press and hold the “• PROG/STOP” key down for
5 seconds: the LED of the “PROG/STOP” key will
ash and all keys on the push-button panel being
programmed will turn on;
ll the lter with a dose of ground co ee and •
press it with the co ee press;
attach the porta lter to the delivery group;•
put the co ee cup under the dispensing spout •
(16);
press the desired dose •
key (e.g.: “1 Espresso”
);
wait for delivery;•
to con rm the desired •
dose press again the
dose key or the "PROG/
STOP" key;
once the dose is con rmed, the LED of the pro-•
grammed key switches o and only the keys yet
to be set remain on;
repeat this operation for the other dose but-•
tons;
upon completion of programming, press the •
“PROG/STOP” key to exit dose programming.
16
i
After 30 seconds of idle time, the machine
will automatically exit the dose programming
mode, confirming the already programmed
ones.
i
All models are provided with 2 keys for the
dispensing of hot water. These can be pro-
grammed individually and supply doses which
are independent from one another.
i
The 4GR version has 2 hot water nozzles. The
left key controls the left hot water nozzle,
while the right key controls the right hot water
nozzle.
i
The programming of each dose must be carried
out with ground co ee and not with previously
used co ee grounds.
i
It is possible to program all the push-button
panels of the machine simultaneously using
only the left push-button panel. To obtain dif-
ferent doses for the various groups, perform the
programming by starting with the left push-
button panel and then all the others.
To Next Page
Loading...
Need help?
General
