17
Wegaconcept
User manual
ENGLISH
11.1 Automatic heating and foaming
Proceed as follows:
Immerge the tips of the autosteamer (• 13) into
the beverage;
press the •
or key, depend-
ing on the dose of milk in the jug;
wait until the dispensing is fin-•
ished;
when the dispensing has nished, •
the milk will be foamed and heated
to the preset temperature.
To stop dispensing ahead of time, press the same •
key;
to prolong the dispensing of steam, use the key •
“Manual steam”
.
13
A
To increase or decrease the consistency of the
foam, slightly adjust the special regulator (A). Turn-
ing it clockwise will decrease the consistency, while
turning it counterclockwise will increase it.
Always proceed by performing slight adjust-
ments.
11.2 Automatic heating
Proceed as follows:
Immerge the tips of the autosteamer (• 13) into
the beverage;
press the •
key;
wait until the dispensing is nished;•
once the dispensing has nished, the milk will •
be heated to the programmed temperature, but
not foamed.
To stop dispensing in advance, press the same •
key;
to prolong the dispensing of steam, use the key •
“Manual steam”
.
11.3 Manual heating and foaming
This control allows the user to use the auto-
steamer nozzle to heat and at the same time foam
the milk, letting him use it manually.
Proceed as follows:
Immerge the tips of the autosteamer (• 13) into
the beverage;
press the •
key;
To stop dispensing, press the same key again.•
11.4 Automatic cleaning
After 120 minutes of idle time the automatic
cleaning of the nozzle starts, lasting 15 seconds.
The message will appear on the display: "STEAM
CLEANING CYCLE"
A minimum amount of steam will exit the nozzle.
!
The autosteamer foaming is factory-adjusted,
in the testing phase of the machine. Therefore,
it is recommended to modify the adjustment
only if strictly necessary.
To Next Page
Loading...
Need help?
General
