28
Wegaconcept
User manual
19 Display indications
GR.X FLOW TOO FAST
CONSULT THE HANDBOOK
Coarse grinding: reduce the grinding degree.•
Short co ee dose: adjust the dose on the grinder-doser.•
Ground co ee too old: use fresh-ground co ee.•
Ambient humidity lower than usual: slightly reduce the •
grinding degree.
GR.X FLOW TOO SLOW
CONSULT THE HANDBOOK
Fine grinding: increase the grinding degree•
Long co ee dose: adjust the dose on the grinder-doser•
Ambient humidity higher than usual: slightly increase the •
grinding degree
Hydraulic circuit obstructed: contact the Technical Sup-•
port Service
GROUP WASHING
The group washing needs to be carried out as indicated •
in paragraph 15.
ENERGY SAVING
All the groups are in stand-by or the entire machine (in-•
cluding the services boiler) is in energy savings phase.
+ ashing of the STOP/PROG LEDs
-- OFF --
The machine is o in automatic mode.•
The LED of the STOP/PROG key remains lit
constantly.
Delivery group o .•
The LED of the STOP/PROG key is ashing
One or more delivery groups (but not all) are in stand-by.•
!
If indications other than those indicated above should appear or if the machine presents any type of failure, turn
the machine o and contact the Technical Support Service. Any repairs that are not carried out by an authorised
service centre, in addition to compromising the machine's safety, may seriously damage the equipment and
render the guarantee null and void.
To Next Page
Loading...
