16
Wegaconcept
User manual
11 Autosteamer
(
*
)
The "Autosteamer" sys-
tem can be used for au-
tomatically heating and
foaming milk to the pro-
grammed temperature.
It can be controlled
using the keypad (15)
located on the left base of
the machine.
15
13
OFF
MILK
(*) optional.
!
Carefully move the steam nozzle using the anti-
burn rubber bulb (6) and never touch the steam
nozzle (7) or the hot water nozzle (12): contact
with the hot water or steam may be harmful to
individuals, animals or property.
!
The use of the steam dispensing point (steam
nozzle), must always be preceded by the per-
formance of the condensation draining opera-
tion for at least 2 seconds.
!
To keep the steam nozzle tips in perfect working
order, it is advisable to carry out a brief delivery
dry run after each use. Keep the tips clean at
all times using a cloth dampened in lukewarm
water. Handle the nozzle with utmost caution
due to the hazard resulting from the presence
of high-temperature steam.
!
LEAVE THE STEAM NOZZLE IMMERGED IN THE
MILK ONLY FOR THE TIME REQUIRED FOR HEAT-
ING. DO NOT OPEN THE STEAM TAP WITH THE
STEAM NOZZLE IMMERGED IN MILK WHILE THE
MACHINE IS OFF.
To obtain an optimal foaming, it is recommended
to observe the following simple rules:
heat only the amount of milk you intend to use, •
once heated, the milk will have to be completely
poured from the jug and mustn't be heated
again;
the autosteamer guarantees a correspondence of •
± 3°C between the set temperature and the real
temperature of the milk, only by starting from a
milk temperature of 4°C;
since the dispensing of steam stops on its own •
when the set temperature of milk is reached, to
prevent the milk foam spilling out, it is necessary
to introduce a volume of liquid not higher than
1/2 of the capacity of the jug.
use a container with a capacity of 0.75 liters and •
ll it to the half with milk;
set a maximum heating temperature of 60 °C •
(contact the technical service).
Short autosteamer dose
Long autosteamer dose
Automatic heating
Manual steam +
foaming
To Next Page
Loading...
Need help?
General
