23
Wegaconcept
User manual
ENGLISH
Regeneration noti cation
If the function has been enabled during program-
ming, the system measures the amount of water
used by the machine and signals on the display
(with the ashing phrase "WATER SOFTENER REGEN-
ERATION") the need for regeneration when the set
amount has been exceeded.
Once the regeneration has been carried out, the
counter must be reset.
14.2 Cappuccino maker
Put the suction tube inside the milk;•
place the jug under the spout of the cappuccino •
maker;
open the steam tap, when the desired amount is •
reached close the steam tap;
pour the foamed milk into the cups with co ee.•
Z
Cleaning
Use special care in cleaning the cappuccino
maker, following the procedures indicated below:
perform a rst washing by immerging the suc-•
tion tube in water and run a delivery for a few
seconds;
turn the rotating body (• X) 90° to position B (clo-
sure of milk outlet duct);
holding the milk suction tube in the air, dispense •
steam (cappuccino maker dry run);
wait about 20 seconds to allow for internal clean-•
ing and sterilisation of the cappuccino maker;
close the steam and put the rotating body back •
in position A;
if the air intake hole (• Y) is blocked, clear it gently
with a pin.
X
Y
i
To reset the litres count, contact specialised
personnel.
i
To obtain the dispensing of warm milk without
foam, lift the tab (Z) upwards. For better re-
sults, we suggest not to dispense directly into
the co ee cup, but into a jug or pot, and to then
pour the foamed milk on the co ee. Be sure the
cappuccino maker is kept clean as described in
the chapter "Cleaning".
!
It is advisable to clean the cappuccino maker
after each period of continued use so as to
avoid malfunctions and to ensure a high rate
of hygiene in the system.
Pos.A Pos.B
To Next Page
Loading...
Need help?
General
