11
11. Grease an M10 x 51mm Bolt (66). Attach a Cable
Pivot (39) to the Right Arm (9) with the Bolt and
a
n M10 Nylon Locknut (56). D
o not overtighten
the Nylon Locknut; the Cable Pivot must pivot
e
asily.
Wet the inside of a Large Foam Pad (42) with
soapy water. Slide the Large Foam Pad onto the
Right Arm (9).
Attach the upper end of a Handle (11) to the
Right Arm (9) with an M10 x 67mm Bolt (71), two
M10 Washers (57), two 12mm Spacers (52), and
an M10 Nylon Locknut (56).
Do not tighten the
Bolt yet.
Press a 50mm Round Handle Cap (31) into the
Right Arm (9), over the Handle (11). Attach the
lower end of the Handle to the Right Arm with an
M10 x 45mm Button Bolt (77) and an M10 Large
Washers (80).
Tighten the M10 x 67mm Bolt
(71).
Assemble the Left Arm (10) in the same way.
12. Grease an M10 x 85mm Bolt (67) and two Arm
Bushings (44). Attach the Right Arm (9) to the
Pivot Frame (5) with the Bolt, two M10 Washers
(57), the two Arm Bushings, and an M10 Nylon
Locknut (56). Do not overtighten the Nylon
Locknut; the Right Arm must pivot easily.
Attach the Left Arm (10) to the Pivot Frame (5)
in the same way.
13. See the CABLE DIAGRAM on page 21 to iden-
tify the cables while you assemble them.
Identify the Arm Cable (54). Grease an M8 x
22mm Shoulder Bolt (65). Attach the Cable to the
indicated Cable Pivot (39) with the Shoulder Bolt
and an M8 Nylon Locknut (58).
11
12
11
10
39
31
77
80
66
52
52
5
7
71
56
56
57
9
10
42
9
44
56
57
5
57
67
58
65
54
39
44
Grease
Grease
G
rease
Grease
13
Cable Assembly
To Next Page
Loading...
Need help?
General
