Weider PRO 3750 - Page 12

ii ]
ii i
m
¸ILl¸
u)
iil,l,I _
t,J
%
21. Wrap the Butterfly Cable (89) around a 3 1/2"
Pulley (82) as shown. Attach the Pulley and a
Cable Trap (80) to the bracket on the Leg
Press Upright (4) with a 3/8" x 2" Bolt (50)
and a 3/8" Nylon Locknut (42). The Cable
Trap must be oriented to hold the Cable in
the groove of the Pulley.
22.
Locate one of the preassembled pairs of
Pulley Plates (31) and 3 1/2" Pulleys (82).
Route the Butterfly Cable (89) under the indi-
cated 3 1/2" Pulley (82). The end of the Pulley
Plates (31) with two holes should be down-
ward. Refer to the inset drawing. Make sure
that the Cable is between the Cable Trap
(80) and the Pulley, and that the Cable Trap
is positioned to hold the Cable in place.
Tighten the 3/8" x 2" Bolt (50) and the 3/8"
Nylon Locknut (not shown).
23.
Wrap the Butterfly Cable (89) around a 3 1/2"
Pulley (82) as shown. Attach the Pulley and a
Cable Trap (80) to the other side of the bracket
on the Leg Press Upright (4) with a 3/8" x 2"
Bolt (50) and a 3/8" Nylon Locknut (42). The
Cable Trap must be oriented to hold the
Cable in the groove of the Pulley.
24. Note: The Left Fly Arm (6) is shown
removed for easier part identification.
Attach the Butterfly Cable (89) to the Left Fly
Arm (6) with a 5/16" x 1" Shoulder Bolt (51)
and a 5/16" Nylon Jamnut (91).
21
23
24
End with
two holes
should be
II down
91
I
12