30 EN WM 100 TD
WM 67841c 03/2015
4 Preparation
4 Preparation
4.1 Setting up the therapy device
1. Place the therapy device on a flat surface (e.g., a bedside table).
2. Leave the suction area of the therapy device uncovered.
3. Keep the power plug and power socket accessible at all times.
4. Pull the protective foil off the device.
Result The therapy device is set up properly.
4.2 Connecting components
4.2.1 Connecting up the power supply
Material damage due to overheating!
Temperatures which are too high can cause the therapy device to
overheat and damage the device.
The therapy device and power supply unit must not be covered
with textiles (e.g., bedclothes).
Do not operate the therapy device close to heating systems.
Do not expose the therapy device to direct sunlight.
Do not operate the therapy device in the transport bag.
Risk of injury due to electric shock when connecting an
incorrect power supply unit to the line power!
The power supply unit contains a safety device to prevent electric
shock. The use of a non-original power supply unit may result in
injury to the user and the patient.
Only operate the device on line power using the power supply
unit recommended by Weinmann.
To Next Page
Loading...
Need help?
General
